Security Control Systems Ltd Home
  About Us   Vacancies   Contact Us | Call Us On: 0118 978 3381
For peace of mind be SCS Secure

Programme Instructions

Step by step guide to programme a new fob for your system

Remote Control Fobs are supplied in three styles The grey one has been around for a while, the white one is the current model, the black fob is a 4 button design. All fobs operate in the same way and the programming steps are identical. For the 4 button fob use buttons 1 & 2 to start.

You will need the fob that you currently use to successfully operate your system. This is the Master Fob   You will also need the fob that has been supplied to add to your system. This is the Slave Fob

The main features of the fob are shown here.
You can check if the fob is a master or a slave by pressing any button.
If the LED flashes before showing a steady light it is a Master Fob
If the LED immediately shows a steady light it is a Slave Fob

Programme Steps

Step 1
Press and hold down both buttons on the Master Fob.
After a few seconds the LED will start to blink.
Release both buttons and the LED will continue to blink steadily.

Step 2A - While the LED on the Master Fob is flashing, press and hold down the button on the master that you wish to transfer to the new fob.

Step 2B - Point the LEDs at one another and press the equivalent button on the Slave Fob. The LED on the slave fob will flash twice to confirm transfer and then go out.

Step 2C - First release to button on the slave then release the button on the master


Your fob is now programmed.

Repeat, if required, for the other button.



Our brands include:
EMCS Scantronic Texecom

Our accreditations include:
Safe Contractor Approved NSI
Privacy Statement    |    Terms & Conditions    |    Contact Us    |    About Us    |    Sitemap
© Copyright 2012 SCS Systems Ltd.
Web Design by:
Metakinetic